After a marathon 7 day sessions, all or at least most of the decals have been applied. I have to say I was really impressed with Begemot decals. They are very thin, much thinner than AMK ones, as mentioned in my review, the print is thinner too and they really look great on the model. They literally suck into panel lines by themselves and no decal softener was needed. I will have at least one more decal session when I’ll finish the weapons, but the main thing is done! The only criticism in practical application of Begemot decals was, that there were errors in the instructions – I’ve hit a few mislabeled stencil decals. On the other hand, placement instructions are clear, so you can figure the correct decal just by comparing the shape of decal to the instructions and if there are L/R side opposite decals, they are labeled as, for example, 89 for the left and 90 for the right side. Decals being done, it’s time to dirty her up a bit 😉